Kejljug Water Underfloor Heating Manifold

A stainless water underfloor-heating manifold — the hub that splits the hot water into the floor loops, balances the flow to each room and lets you control them by zone. Flow meters, isolating valves and actuator ports for room thermostats; plumbed in, balanced and pressure-tested by a competent installer.

• Type: stainless water UFH manifold
• Function: splits and balances flow to the floor loops by zone
• Build: flow meters, isolating valves, actuator ports
• Install: plumbed, balanced and pressure-tested by a competent installer

For indoor domestic use. Underfloor heating is built into the floor and must be installed to the manufacturer's instructions and the applicable building and electrical rules. An electric mat or cable is a mains circuit: it must be connected by a qualified electrician on an RCD-protected supply, used with its floor sensor and thermostat, never cut, shortened or crossed over itself, and tested for insulation before and after the floor is laid. A water system must be pressure-tested and connected by a competent installer at the correct flow temperature. Let adhesives and screed cure fully before switching the heating on, and follow your floor covering's temperature limit. CE marked where applicable. The statutory 14-day right of withdrawal applies to consumers.