Kejljug Underfloor Heating Thermostat

A programmable underfloor-heating thermostat with a floor-sensor input — set the temperature and a daily schedule so the floor is warm when you need it and off when you don't. A clear display and a floor-limit setting; wiring by a qualified electrician on an RCD-protected supply.

• Type: programmable UFH thermostat
• Control: schedule, floor-sensor input, floor limit
• Install: wired by a qualified electrician, RCD-protected

For indoor domestic use. Underfloor heating is built into the floor and must be installed to the manufacturer's instructions and the applicable building and electrical rules. An electric mat or cable is a mains circuit: it must be connected by a qualified electrician on an RCD-protected supply, used with its floor sensor and thermostat, never cut, shortened or crossed over itself, and tested for insulation before and after the floor is laid. A water system must be pressure-tested and connected by a competent installer at the correct flow temperature. Let adhesives and screed cure fully before switching the heating on, and follow your floor covering's temperature limit. CE marked where applicable. The statutory 14-day right of withdrawal applies to consumers.