Kejljug Single-Room Water Underfloor Heating Kit

A single-room water underfloor-heating kit — the pipe, the clip rail or panels, the edge strip and a small manifold to warm one room from the heating system or a heat pump, gentle, even heat across the whole floor. Sized for a room area; pressure-tested and connected to the heating by a competent installer at the correct flow temperature.

• Type: single-room water UFH kit
• Includes: pipe, clip rail / panels, edge strip, small manifold
• Benefit: even floor heat from the heating system or heat pump
• Install: pressure-tested and connected by a competent installer

For indoor domestic use. Underfloor heating is built into the floor and must be installed to the manufacturer's instructions and the applicable building and electrical rules. An electric mat or cable is a mains circuit: it must be connected by a qualified electrician on an RCD-protected supply, used with its floor sensor and thermostat, never cut, shortened or crossed over itself, and tested for insulation before and after the floor is laid. A water system must be pressure-tested and connected by a competent installer at the correct flow temperature. Let adhesives and screed cure fully before switching the heating on, and follow your floor covering's temperature limit. CE marked where applicable. The statutory 14-day right of withdrawal applies to consumers.