Kejljug Whole-House Water Underfloor Heating System

Our flagship: a whole-house multi-zone water underfloor-heating system — the manifolds, the pipe, the clip panels, the edge insulation and the zone controls to warm a whole home evenly from a boiler or a heat pump, the comfortable, low-temperature way to heat. Planned to your floor areas and zones; designed, pressure-tested and commissioned by a competent heating installer at the correct flow temperature.

• Type: whole-house multi-zone water UFH system
• Includes: manifolds, pipe, clip panels, edge insulation, zone controls
• Benefit: even, low-temperature whole-home heat from a boiler or heat pump
• Install: designed, pressure-tested and commissioned by a competent installer

For indoor domestic use. Underfloor heating is built into the floor and must be installed to the manufacturer's instructions and the applicable building and electrical rules. An electric mat or cable is a mains circuit: it must be connected by a qualified electrician on an RCD-protected supply, used with its floor sensor and thermostat, never cut, shortened or crossed over itself, and tested for insulation before and after the floor is laid. A water system must be pressure-tested and connected by a competent installer at the correct flow temperature. Let adhesives and screed cure fully before switching the heating on, and follow your floor covering's temperature limit. CE marked where applicable. The statutory 14-day right of withdrawal applies to consumers.